Mô đun điều khiển vị trí FX3U-20SSC-H

FX3U-20SSC-H

FX3U-20SSC-H type positioning block (hereinafter referred to as 20SSC-H) is a special
function block applicable to SSCNET III.
20SSC-H can perform positioning control by servo motor via SSCNET III applied servo
amplifier

Major Features of the FX3U-20SSC-H
1) 2-axis control is possible
One 20SSC-H controls 2 axes.
20SSC-H applies the 1-speed positioning and interrupt 1-speed constant quantity
feed operations for constant quantity feed control, and also the linear interpolation
and circular interpolation operations.
2) Connection to servo amplifier by SSCNET III is possible
– 20SSC-H connects directly to the MELSERVO (our company’s servo amplifier:
MR-J3-…B, MR-J3W-…B*1, MR-J3-…BS*2, MR-J4-…B*3) via SSCNET III.
– Connection using the SSCNET III cable between the 20SSC-H and the servo
amplifier and between servo amplifiers reduces wiring. (Maximum length is 50m.)
– Using the SSCNET III cable (optical communication) makes connections less
susceptible to electromagnetic noise, etc. from the servo amplifier.
– Setting the servo parameters on the 20SSC-H side and writing/reading the servo
parameters to/from the servo amplifier using SSCNET III is possible.
– Actual current values and error descriptions the servo amplifier can be checked
by the buffer memories of the 20SSC-H.
*1 The MR-J3W-…B can be connected within the functional range of the MR-J3-…B
to the 20SSC-H.
*2 The MR-J3-…BS can be connected to a 20SSC-H later than Ver.1.40.
However, it does not support the fully closed loop system.
*3 The MR-J4-…B can be connected within the functional range of the “J3
compatibility mode” to the 20SSC-H

Applicable PLC

Tài liệu chi tiết xin vui lòng xem tại

http://dl.mitsubishielectric.com/dl/fa/document/manual/plc_fx/jy997d21101(e)/jy997d21101(e)j.pdf

Để đặt hàng xin vui lòng liên hệ 0936.296.483